You are looking at the Molex 4 Pin Power Male Terminal (5 count). This terminal is used on many 4 Pin cables extensions on a power supply and are of Molex Brand or Molex Brand quality. They are mainly used to make an extension to extend the current cables.
I have searched high and low to to bring you the best quality of terminals that will hold firmly and work in any crimper out there. More-so these terminals will crimp perfectly in the LC Crimp Tool.
I am selling these in 5 counts as I believe this to be the best number to multiply by so you can have the right number of terminals.
Remember when buying terminals you should always buy at least 20 extra for mistakes and learning to crimp in the first place so you don’t have to make another order.
justash (verified owner) –
No complaints, easy to crimp and they come out looking great.
justash –
Sevan (verified owner) –
I only tested those terminals on 16AWG wires but it actually worked well with it. Given I couldn’t afford for a molex crimper I tried with the LC ATX crimper… which worked well : the terminal holds well on the cable. I may go for a molex crimper when I’ll need it and when MainFrame Customs will sell one with a good price !
Sevan –
kevzhu (verified owner) –
Worked ok for me. Ruined 1 or 2 before I got the hang of it but they are cheap
kevzhu –
mrnuke (verified owner) –
This terminal does NOT work with the LC Ratchet crimper. The conductor crimp on this terminal is not wide enough for the LC crimper. If one positions the terminal to obtain a good bell mouth, the contact area will be crushed, destroying the terminal. If one positions the terminal to avoid crushing the contact area, the crimp will have no bell mouth.
The insulation crimp tabs are also too small to fully encompass the insulation of 18 AWG wire. 20 AWG wire won’t be crimped securelly with the LC crmper. I thought the terminal might have been designed for smaller gauge wire, but the excessive extrusion when crimped with a smaller die says otherwise.
mrnuke –